On Resources: My Experience Explained

Wood Preservation Methods

The Biological research of wood and it’s renewable material is what is referred to as wood science. In other words, the term wood science can also be known as wood technology. To be able to study wood it has to be compared to other products. Materials properties, ease of it being worked on and its value are among the few properties which are compared against those of wood and other materials. The utilization of technology gives wood an upper hand in most of this comparison. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. Once a tree has been cut down another can be planted in the same spot. The other merit is that a part of the harvested material is at the same time used as energy to produce the product.

For your wooden products and house to stay for long and have a good appearance it needs to be protected. The biggest threat to wood being moisture and insects has to be kept away from the wood. The rotting and decay of the timber products are caused by the moisture and the insects. Many methods are available in the treatment of wood one of the most common being the ACQ – alkaline copper Quaternary. This is a copper-based preservative that is applied to the wood for protection. There are a few disadvantages of this method as a mode of wood preservation. It is a highly corrosive chemical that affects most metals that are used together with the wooden products. The saturation level of any treatment will depend on where the wood is going to be used and the species of the wood. Timber being used around a water body will be dipped in a more saturated fluid than that being used above ground.

Another wood treating method that is fast being accepted is the use of copper metal. The use of this method is fast being accepted because it is not corroding the metal fasteners. An alternative name to be given to this method is the micronized copper wood preservative method. In this process microscopic particles of solid copper metal are mixed in a liquid carrier and injected to the wood at high pressure. The difference between this method and the other copper-based methods is that the copper is used as a metal rather than a dissolved material. When this process is used to treat timber the timber properties are increased highly. The timber treated in this way is used in both outdoor and indoor frames that last very long.

Termites and fungal decay are just a few among the many problems wood treated from this method are protected against. Unlike other methods of treatment this method is not corrosive. When you use this method to treat wood, then you will not need to worry for at least ten years.